Two Cards - One Hour

 

Christmas Card Throwdown's Technique challenge this week has been "Quick Card." Basically, make a card in 30 minutes or less. Sounds easy, right? Well, suffice it to say my first attempt went over the 30 minutes by about 25 minutes more. Thankfully, I was able to scale back & get not just one, but 2 cards that meet the time constraint!

 

For my first card, I pulled out an oldie but a goodie - "Lovely as a Tree" from Stampin' Up (sadly discontinued). I began by cutting a white cardstock panel to 7x5". I used yellow Frog Tape to mask off the edges, leaving a rectangle in the middle. Then I stamped one of the images with Simon Says Stamp's Mint Candy ink. I wanted a misty appearance, inspired by this card, & this light green fit the bill quite nicely.

 

Without removing the tape, I ink blended in the center rectangle with Bundled Sage. Cracked Pistachio, & Iced Spruce Distress inks. I added extra Iced Spruce around the edges to darken them slightly for a vignette effect. Then I carefully removed the tape, being sure not to peel any of the cardstock up.

 

I stamped the pine tree from the same set off to one side with Simon Says Stamp's Laurel Green ink. I actually stamped it twice (thank heavens for the MISTI!) to get a slightly darker impression. I stamped the greeting, from WPlus9's "Poinsettia Bouquets" (discontinued) in that same color. For the snow on & under the tree, I daubed embossing ink on with a Distress embossing pen, then sprinkled Hero Arts' White Puff embossing powder over that. I brushed off some of the powder, as I'd gotten a bit heavy-handed with the ink, then melted what remained with my heat gun. Finally, I adhered my panel to an A7 card base.

 

 The inspiration for my second card came from this card by Chari Moss. I liked the glittery greenery & the simple CAS design.

 

I die cut the greenery & berries, from the Essentials by Ellen "Poinsettia & Pine set (discontinued), from green & red glitter cardstocks. For the background, I pulled an A2-size cream cardstock panel from my pre-cut card fronts stash. I stamped the greeting, from the Essentials by Ellen "Mistletoe & Holly" set (discontinued) in Candied Apple Distress Oxide ink. Again, my MISTI came in clutch, since I had to stamp it a few times to get a good impression. I trimmed the panel down to 4x5-1/4", and matted it with a dark brown cardstock that I'd adhered to a white A2 card base. I glued my greenery & berries at the top of the panel. I added the glue only to the stems, so the die cuts kind of "hang" freely. Finally, I tied a triple bow from gold DMC Diamant thread & adhered it to the top of the greenery. I don't normally do something this "bare," but I really like how it came out!

 

I'm also entering my first card in The Paper Funday's October "Anything Goes" Challenge (not playing the optional twist).

Wishing You a Year of Joy

 

 

The theme for Double Trouble's challenge this time around is "Shades of Fall." As usual, it is a recipe challenge using at least the number of the following ingredients: 3 colors (shades of Fall), 2 images, 1 stenciled or dry-embossed element. As you notice, I have flowers on my card. Flowers (except maybe for mums) don't exactly scream Fall - unless you live in the South. Here in Texas, our flowers (including mums) bloom sometimes into November. Below is a photo I shot at a pumpkin display here in our town in October of 2023. The purple flowers in that display helped inspire my color palette for my images.

 

Pumpkin Wonderland

 

I began with my background. I had applied the molding paste to my panel, using the "Ribbon Weave" stencil from A Colorful Life Designs quite some time ago, & it's been sitting in my stash ever since. I decided it would work perfectly for this card. I placed the stencil back over the panel, lining it up with the molding paste design, & ink blended with Abandoned Coral, Dried Marigold, & Fossilized Amber Distress Oxide inks (my 3 shades). I decided to go with basically a pastel Fall color scheme, since the background is more of a supporting character to my main images.

 

I die cut my images from Strathmore Mixed Media paper, using the smaller flowers & leaves in the "Brushstroke Flowers #2" set from Sizzix/Tim Holtz. This is a new-to-me set, so I was glad to be able to use it. I used my DIY Distress Spray Stains (a la Tiffany Solorio) in Milled Lavender, Seedless Preserves, Mustard Seed, Shabby Shutters, & Rustic Wilderness to color scraps of the paper before die cutting. After I had die cut the flowers, leaves, & flower centers from the papers, I felt they still looked a little flat. So I got Tombow water-based markers in purple & green, and kind of flicked & tapped with the brush tip onto each main die cut. I also colored the layering pieces with the markers to make them darker. Then I spritzed all the pieces generously with water to get the marker color moving & dried them with my heat gun. That gave me the effect I wanted. After they were all thoroughly dry, I glued the layers for each piece together.

 

I stamped my greeting, from the "Sentiment Strips: Birthday" set from Pretty Pink Posh, in Abandoned Coral Distress Oxide ink onto white cardstock. Then I die cut that with one of the "Sentiment Strips" dies. I arranged my flowers & leaves & glued them together so I could work with them as one unit. After the glue dried, I positioned them & my greeting strip on the background panel & glued them down. Finally, I added my panel to a white A2 card base that I'd adhered a yellow mat layer to.

 

I'm also entering my card in the following challenges:

 

Die Cut Divas October Challenge: "Anything Goes"

Simon Says Stamp's Wednesday Challenge: "Clean & Simple"

613 Avenue Create October Challenge: "Anything Goes" (not playing the optional twist)

The Paper Funday Challenge: "Anything Goes" (not playing the optional twist)

All Sorts Challenge #835: "Autumn Colors"

Woody Merry Christmas

This week's challenge at Christmas Card Throwdown is to use red, green, & brown on a holiday card. I have had this "Christmas" stamp from Recollections of a woody car carrying a tree (discontinued) literally for years & had never inked it up. I decided this was the perfect opportunity to use it.

I began by stamping the image onto a scrap of Canson XL watercolor paper. I painted it with my watercolors, using a gold watercolor from the Fine-Tec Pearlescent Colors to paint the baubles on the wreath & garland. After it had dried, I used my craft knife to cut out the windows, and then fussy cut around the outside of the image with my scissors. I used a black brush-tip marker to "paint" all the exposed edges of the watercolor paper, just to make everything look more seamless. When I had finished all that, I just kind of looked at it & wondered where to go from there.

My first instinct was a snow globe shaker card, but because of the length of the car, it would have been a massive snow globe, unless I made it oval-shaped, which I wasn't too keen on. I also toyed with the idea of stamping some pine branches onto my card front & "hanging" the car from them, as if it were a Christmas ornament. I finally decided to stop overthinking it & just make a traditional shaker card (minus the snow globe element).

I found a piece of burgundy patterned paper in my scrap stash that was big enough to use as a panel on my 6-1/2 x 5-1/4" card. I cut that panel to 1/16" smaller than my card base on each side, & used a "Nesting Ovals Die" from Waffle Flower to cut the center window. I cut a piece of white cardstock the same size, & die cut a window with the next smaller oval die, so it would create a mat around my shaker window. Then I adhered those panels together.

I cut a piece of kraft cardstock slightly smaller than my burgundy & white panels, & adhered my image to that. To create "snow," I used a Ranger Distress Embossing Dabber to pounce embossing ink through the "Falling Snow Splatter" stencil from Simon Says Stamp onto my panel & car. I sprinkled on Hero Arts White Sparkle embossing powder & melted that with my heat gun. To further enhance the snowy scene, I applied ink with the Embossing Dabber to the car tires & area under the car & heat embossed with the same powder.

I used double-sided tape to adhere a piece of Grafix Dura-Lar acetate to the back of my window panel. Before adding my foam tape, I went ahead & stamped the greeting, from Hero Arts' "Holiday Cardinal" set, with StazOn Cotton White ink onto the acetate. Then I added 2 layers of foam tape all around the edges with diagonal pieces of tape in the corners closer to the oval window. I removed the backing paper from the foam tape, & poured in some clear seed beads, being careful not to let the panel "jump" & send any beads flying. Finally, I adhered a second piece of acetate to the foam tape to seal in the beads. (This was a trick I learned from Nina-Marie Trapani, to provide less friction to anything inside the shaker.)

To adhere my image panel behind my shaker, I added double-sided tape to the back piece of acetate on my shaker panel. I peeled back part of the liner paper on each strip to expose only some of the adhesive. (I got that trick from Julie Ebersole.) Then I carefully positioned the window over the image panel so the car was centered side-to-side within the window & not directly behind the greeting. I pressed the panel down so the exposed adhesive stuck to the corners of the image panel, & then carefully pulled back the remainder of the liner paper. I made sure everything stuck securely. I added a 6-1/2 x 5-1/4" kraft panel to my white card base, & finally adhered my shaker panel to the card front with tacky glue. This way I can make sure it will NOT fall off!

I'm also entering this card in the following challenges:

Allsorts Challenge #834: "Traditional Christmas Colors"
Little Red Wagon Challenge #829: "Captain's Log" (painted woodgrain pattern on the Woody car panels)
613 Avenue Create October 2025 Challenge: "Anything Goes" (not playing the optional twist)
Die Cut Divas October Challenge: "Anything Goes"
The Paper Funday October Challenge #81: "Anything Goes" (not playing the optional twist)
Simon Says Stamp Wednesday Challenge: "Get Ready for Christmas"